CaneTalk: Re: Hr. 96 has it making it through the gap

Re: Hr. 96 has it making it through the gap

Posted by Gambit7 on 9/1/2019, 2:57 am

The path the trough "cuts" is narrower in the newer run. Follow the 1016 isobar.

118

In this thread:

00z Runs in - Gambit7, 9/1/2019, 1:30 am

Re: 00z Runs in - martyintampa, 9/1/2019, 4:33 pm
- No posts like this in the future from anyone - Chris in Tampa, 9/1/2019, 6:35 pm
- Re: 00z Runs in - beachman80, 9/1/2019, 6:31 pm
- Are you serious? - Beachlover, 9/1/2019, 5:32 pm
  - I am confused, too. - karen, 9/1/2019, 6:15 pm
  - Re: Are you serious? - stevemc12, 9/1/2019, 5:59 pm
- Re: 00z Runs in - martyintampa, 9/1/2019, 4:48 pm
Re: 00z Runs in - stevemc12, 9/1/2019, 8:47 am
Re: 00z Runs in - knuckle, 9/1/2019, 5:57 am
- Re: 00z Runs in - Chris in Tampa, 9/1/2019, 6:23 am
  - Re: 00z Runs in - jimw, 9/1/2019, 6:53 am
    - Re: 00z Runs in - knuckle, 9/1/2019, 8:39 am
      - Re: 00z Runs in - Chris in Tampa, 9/1/2019, 8:55 am
        Re: 00z Runs in - knuckle, 9/1/2019, 9:03 am
Re: 00z Runs in - Beachlover, 9/1/2019, 2:05 am
- Re: 00z Runs in - Gambit7, 9/1/2019, 2:14 am
  - Hr. 96 has it making it through the gap - Gambit7, 9/1/2019, 2:16 am
    - Re: Hr. 96 has it making it through the gap - Beachlover, 9/1/2019, 2:47 am
      - Re: Hr. 96 has it making it through the gap - Chris in Tampa, 9/1/2019, 2:58 am
        When I say closer by "not much" that was a poor word choice - Chris in Tampa, 9/1/2019, 3:01 am
        And I want to correct my correction - One more shift like that and Florida would be getting hurricane force winds - Chris in Tampa, 9/1/2019, 3:24 am
        Re: And I want to correct my correction - One more shift like that and Florida would be getting hurricane force winds - Gambit7, 9/1/2019, 3:33 am
        wait - Gambit7, 9/1/2019, 3:42 am
        nvm - Gambit7, 9/1/2019, 3:58 am
      - Re: Hr. 96 has it making it through the gap - Gambit7, 9/1/2019, 2:57 am

< Return to the front page of the: message board | monthly archive this page is in

Post A Reply

This thread has been archived and can no longer receive replies.